Description

The Perfect Choice for Premium Pillars and Parts The pillars are 1/2'' (.4995) in diameter, CNC machined, and made of T6 6061 aluminum. These pillars are left long so that they can be trimmed to length by the installer, depending on the specific stock that you have. If the pillars are cut too short they will not do their job. The threaded rod is used to assist in placing the pillars and cutting to them to length. Simply scuff up the exterior with some sand paper prior to installation and be sure to degrease. These can be installed in manners, factory, HS Precision, Boyd's, and McMillian stocks. This a DIY kit. In order to utilize this kit you must drill out the stock, and epoxy or "glue" these into place. Final fit and finish will need to be done during installation. A chamfer may be required on the bottom inner diameter of the pillars to allow for action screw fitment. A drill press is recommended but many have used a hand drill or sand paper around a dowel with some patience. These will only fit the CZ 455 because of the notch for the magazine well. I have other pillars that will fit other actions such as the Remington 700, CZ 457, and Others. I also have Stainless Steel Action Screws and kit for the CZ rimfires. This pillar kit is a great addition to any CZ firearm. Check out our barrel set screws, magazine box screws, and magazine pin, in our store as well. Please ask any and all questions before buying. I simply sell stuff on the side that I do not need. I conduct all business with respect, and try to be professional. I appreciate the same. If something happens please offer a little grace and understanding and contact me about. As a small seller, I work hard to earn good feedback ratings.